Next Actions; Instrument System Calibration; Preliminary Procedure - Raymarine ST70+ Installation Manual

Chapter 3: Commissioning Procedures
4. When AutoLearn is complete and a PASS mes-
sage is displayed, then AutoLearn is complete.
OK
Press
mal operation with the autopilot in Standby
mode, i.e. with manual helm.
If FAIL is displayed, press
AutoLearn process.

Next actions

Proceed with the open water Instrument system calibration.

Instrument system calibration

When the dockside calibration procedures are complete, navigate to a place where
you have plenty of sea room then carry out the seatrial calibration procedures for the
ST70+ Instruments.
The instrument system open water calibration comprises a preliminary procedure
followed by:
• Wind calibration & alignment.
• Speed calibration.
When you have completed the appropriate procedures, proceed to Return to normal
operation.

Preliminary procedure

To carry out any Instrument seatrial calibration procedure, switch on the display, then
when an operational page is displayed:
1. With an Instrument operational page displayed, press
Menu.
2. Scroll to Advanced options.
OK
3. Press
menu..
4. Scroll to the Transducer Setup option, then
OK
press
screen showing a search initiation message.
OK
5. Press
ducers connected to the system.
6. When the search is complete, a Search results
page is displayed.
to leave calibration and return to nor-
OK
to display the Advanced options
, to display the Transducer Setup
again, to initiate a search for trans-
AutoLearn
to repeat the
Advanced options
Search Results
PASS
YOU HAVE THE HELM.
i
Press OK to continue
MENU
to select the Main
Transducer Setup
Press OK to select
Found:
1 Depth
1 Speed
1 Wind
0 DST800
0 DT800
1 Trimtabs
If not correct, press CANCEL and
i
check connections.
Press OK to continue
45