Pacific energy Alderlea T5 Insert Installation And Operating Instructions Manual page 15

2) Remove Top(A) and Shields(B). (Fig. #8)
3) Remove Surround Top and Sides from Packaging.
4) Remove the surround brackets from the stove(Fig. #9) and
attach to the Surround sides as shown in Fig. #10. Use the
bolts and washers in the mounting hardware kit found with
the Surround Top. (Fig #10)
5) Lay Surround sides fl at on fl oor and align with Surround
Top(H). Square the surround by aligning edges(I) on each
side. Fasten bolts (J) to attach bracket.(Fig. #11)
NOTE: If mounting an Oversized Surround (not shown), use
mounting holes (K) to attach.(Fig. #11)
6) Attach surround to fi rebox by aligning with bracket studs (L)
then fasten with washers and nuts (M) on each side.
(Fig. #12)
7) Install fan shield as shown in Fig. #13. Be sure to place the
Fig. # 8
air inlet opening against the surround side.
8) Install the cast decorative top by tilting it at a slight angle,
Fig. # 9
ALT5.ASCINSB 150714-24
A
B
Fig. # 10
F
Fig. # 11
K
I J
Fig. # 12
©PACIFIC ENERGY FIREPLACE
PRODUCTS LTD.
F
F
F
H
K
I
J
15