Maintenance; Troubleshooting - Beamz DMX1360 Instruction Manual

5. Removing the rubber housing for 19" rack fitting
Remove the 4 screws (A, B, C, D) on the side and the 4 screws (E, F, G, H) on the top and bottom. Now
you can mount your DMX1360 Controller in a 19" rack.

6. Maintenance

The Beamz DMX1360 Controller
clean. Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in
liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections with
a damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric
power.

7. Troubleshooting

This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the
steps below in sequence until a solution is found. Once the unit operates properly, do not carry out
following steps.
1. If the device does not operate properly, unplug the device.
2. Check power from the wall, all cables, the fuse, etc.
3. If all of the above appears to be O.K., plug the unit in again.
4. If nothing happens after 30 seconds, unplug the device.
5. Return the device to your Beamz dealer.
requires almost no maintenance. However, you should keep the unit