Beamz DMX1360 Instruction Manual page 13

The joystick patch starts with:
The joystick of the DMX1360 Controller is not standard included in the patch, that's why the word "NONE"
is shown on the spot of the DMX address in the display.
You can change the address by using the DOWN button (18). Press the button, until the display shows
the right DMX address. Now press UP (17), until the display shows: TILT >NONE and then patch the TILT
address. Now select the FIXTURE (3), for which the joystick will be patched. Then press RECORD (15),
the LEDs will flash a moment and the display shows: "GOOD", meaning the patch has been stored.
When, during the steps above, the display shows "ERR", means an error has been made with patching,
example: The patch address is already used, no double channels can be patched.
Follow all steps, until all channels have been set. Then press the ESC button (16) to exit the menu.
3.2 Programming and controlling a moving light effect.
Hold down the RECORD button (15) for 5 seconds, the green LED will illuminate.
The LCD now shows:
Push the PAGE button (5) and use the UP/DOWN buttons (17 & 18) to change the PAGE number, on
which the "scene" or "chase" will be programmed. There are 12 pages and on every page 8 chases and 8
scenes can be programmed. Remember which "chases" are on which page, this makes it a lot easier.
Scene
Select the SCENE (1) and FIXTURE (3) you want to program. By using the faders (4) you can set the
preferred set up. When everything has been set to your need, press the RECORD button (15) to confirm
and all LEDs will flash for a moment. Repeat these steps, until all scenes are programmed.
Chase
Select the CHASE (2) you want to program. Make sure that the "chase" you want to program, is actually
selected. By using the faders (4) you can set the preferred set up. When everything has been set to your
need, press the RECORD button (15) to confirm and all LEDs will flash for a moment. Repeat these steps,
until all steps are in the chase. Press the DEL button (13) to delete the current step, all LEDs will flash
once.
Adjusting the speed of a chase
The speed of a CHASE (2) can be adjusted (during programming) by using the speedfader (25). Hold
down the RECORD button (15) for 5 seconds, and select an empty "chase".
Select a FIXTURE (3), set the faders (4) and move the speedfader. On the left side of the display you can
see the length of every step of the chase (in seconds). All lengths from the steps will be stored in the
"chase".
PAN>NONE
OK ESC SEL ADJ
SELECT A SCENE OR CHASE! PAGE01