Note Number - Beamz DMX1360 Instruction Manual

Notice for CF card
Do not pull out the CF card when being used. Power must be assured "on", when reading or storing to CF
card. Turn off the power when connect or disconnect CF card with the unit.
CF card (32MB) can be used only for DMX1360 Controller; otherwise the data would probably be missing.
Outputting of DMX would be stopped during the reading or storing to CF card. And so does to "ASSIGN
CH." mode.
CF card may become hot during use. Please observe due caution when removing memory cards from
this device.
Take good care of the CF card, and keep it in good conditions.
To clear the memory
Turn off the power, simultaneously holding down the Chase buttons 3, 6 and the Fixture buttons 2, 7, and
atthe same time, turn on the power. LCD will show you :
Memory will be cleared within 5 seconds.
MIDI Implementation
This unit can receive and transmit MIDI NOTE information according to the relevant channels. Please
keep the following list for reference.

NOTE NUMBER

CLEAR MEMORY NOW
PLEASE WAIT.
FUNCTION
23-34 FIXTURE PAGE 1-12
35-50 PAR PAGE 1-16
51-58 FIXTURE SCENE 1-8
59-66 FIXTURE CHASE 1-8
67-72 PAR SCENE 1-6
73-78 PAR CHASE 1-6
79 PAR STANDBY
80 PAR FADE + SPEED
81 FIXTURE BLACKOUT
82 FIXTURE AUDIO
83 PAR AUDIO
84 PAR AUTO
85 PAR STEP
86 FIXTURE MIX/SEQ
87 PAR ONE/MIX/SEQ
88 PAR FULL ON