Beamz DMX1360 Instruction Manual page 17

Fade + speed (36)
With this function you can set the way the steps follow each other. When using a "fade", the set time on
the "speed"-fader (39) will be the fading time between 2 steps. When using a "speed", the set time on the
"speed"-fader will be the waiting time between 2 steps. When the LED is on, FADE has been selected.
When the LED is off, SPEED has been selected.
This function is for "chase" programs as well as "scene" programs.
Audio (37)
When audio is activated, the "chase" will respond to the music via the internal mic. Use the AUDIO fader
to set or adjust the sensitivity of the sound controlled mic.
Full On (38)
When pushing this button, all channels of the conventional light will be at 100%.
One/mix/seq (31)
1) ONE MODE
When the "one" function has been selected, the last selected chase will run. The LED will be off.
2) MIX MODE
When the "mix" function has been selected (LED is on), multiple "chases" will run at the same time. All
selected chases will run.
3) SEQUENCE MODE
When the "seq" function has been selected (LED is flashing), all "chases" will run after each other. The
active "chase" at that time is shown by a flashing LED above that particular "chase".
Note: Switching between "mix"-mode or "sequence"-mode is only possible when all "chases" have been
deselected!
Auto
When the AUTO function (29) has been selected, all programmed "scenes" will follow each other, like one
big "chase".
The speed can be set with the right "speed"-fader.
3.5 Setup menu layout
The Setup menu has 6 functions. You can set these functions by holding down the "setup"-button for 5
seconds. By using the UP/DOWN buttons (17 & 18) you can walk through the menu:
1) CF Card
2) ASSIGN CH
3) P/T FADE ONLY
4) DISPLAY MODE
5) MIDI CH
6) ASSIGN LIST