Pan / Tilt Fade Only - Beamz DMX1360 Instruction Manual

Select relevant location (1-99) by UP/DOWN buttons (17 & 18), and press the RECORD button (15) for
data reading, use ESC (16) to cancel or exit.
Patch channel (assign)
Enter the setting mode to choose "2. ASSIGN CH." and press RECORD (15) to enter channel distributing
mode. LCD shows:
Select the fixtures to be distributed.
Use UP button to select relevant channel number, and press DOWN to select the channel number to be
distributed.
Press RECORD button (15) to confirm, and press ESC button (16) to cancel or exit.

PAN / TILT FADE ONLY

Enter the setting mode to choose item "3. P/T FADE ONLY", and press the RECORD button (15) to enter
"PAN/TILT FADE ONLY" mode. Further information will be shown on the LCD:
Select fixtures by the UP button, and press the DOWN button to select "FADE ONLY" or "FADE ALL".
Press RECORD (15) to confirm your operation, and ESC (16) to cancel or exit.
Display mode (100/255)
Enter the setting mode and choose item "4. DISPLAY MODE", then press the RECORD button (15) to
enter. LCD will show you:
Select mode 100 or mode 255 by UP/DOWN buttons. "100" is for value in percent's (%), "255" is for
values in DMX steps. Press "RECORD" to confirm your operation, use "ESC" to cancel or exit.
MIDI channel
Enter the setting mode and choose "5. MIDI CH.", then press RECORD button (15) to enter the relevant
further operation. LCD will show you:
Select relevant MIDI channels (1-16) by UP/DOWN buttons. Press "RECORD" to confirm your operation,
and use "ESC" to cancel or exit.
CHANNEL1 > OUT1
OK ESC SEL ADJ
FIXTURE1: ONLY
OK ESC SEL ADJ
DISPLAY MODE : X X X
OK ESC CHANGE
MIDI CH. <X X>
OK ESC CHANGE