Installation; Operation - Beamz DMX1360 Instruction Manual

2. Installation

Remove all packing materials from the
removed. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing. Damages
caused by non-observance are not subject to warranty.

3. Operation

Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
3.1 Set up moving light effects
DMX channels 1 to 113 are reserved for the moving lights. Channels 129 to 136 are reserved for the
static DMX channels, at the parcan section (B) of the DMX1360 Controller.
DMX Fixture start addresses are:
FIXTURE1
FIXTURE2
FIXTURE3
FIXTURE4
FIXTURE5
FIXTURE6
FIXTURE7
FIXTURE8
Before you start programming, the console first has to be patched.
Hold down the SETUP button (11) for 5 seconds, the green LED will illuminate. With the UP/DOWN
buttons (17 & 18) you have to choose "2. ASSIGN CH" and then press the RECORD button (15).
The LCD now shows:
This means Controller Channel 1 now sends a signal to DMX address 1. You can change the DMX
address by pressing the DOWN button (18), until you see the address you want. By pressing the UP
button (17), you can change the Channel of your DMX1360 Controller. To save a channel patch, you first
have to select a fixture (3) and then press RECORD (15). Make sure all channels are only used once.
After the display shows:
DMX1360 Controller. Check that all foam and plastic padding is
DMX START ADDRESS: 01
DMX START ADDRESS: 17
DMX START ADDRESS: 33
DMX START ADDRESS: 49
DMX START ADDRESS: 65
DMX START ADDRESS: 81
DMX START ADDRESS: 97
DMX START ADDRESS: 113
CHANNEL01>OUT01
OK ESC SEL ADJ
CHANNEL16>OUT16
OK ESC SEL ADJ