Beamz DMX1360 Instruction Manual page 16

Programming
Hold down the RECORD button (15) for 5 seconds, the green LED will illuminate.
SELECT A SCENE OR CHASE! PAGE01
First press the PAGE button (32). Now you can change the PAGE number (32) with the UP/DOWN
buttons(17 &18).
Press the SCENE (28) or CHASE (30) button, which has to be programmed. Set the faders (38) to the
desired position. The faders (41) have address 129 – 136. These addresses can't be patched. When this
has been done, you can store the step(s) by pressing the RECORD button (15) (a SCENE has one step,
a CHASE has multiple steps).
Exit Record
Press the ESC button (16) when all steps have been entered, then press the button again to exit the
menu.
Play Scene / Chase
The LEDs of the pre-programmed "scenes" illuminate green. The "scenes" of which the LEDs are off, are
not programmed. Press the button of the "scene" or "chase" you want, to activate it. Press the button
again to deactivate. The LEDs from the "chase" only blink after the chase has been activated/selected.
Chases that haven't been programmed can't be selected.
Page (32)
When the PAGE button (32) has been activated, you can view the pages of the conventional light effects.
Fade time
It is possible to add a fade time to the steps. In this way you can beautifully fade in/out a "scene". First
leave the "record"-mode and set the "fade" time with the right "speed-fader" (39). Push the
FADE+SPEED button (36). When the LED is on, FADE has been selected. Now press the "scene" you
want to activate, this scene will now fade-in. When the LED is off, SPEED has been selected.
Step (33)
When a "chase" is running, all steps can be manually walked through by pressing the STEP button (33).
Tap sync (34)
With this function you can press the "chase" speed manually. The speed, with which you press the button,
is the speed of the "chase". This option is often used when the "chase" has to follow the rhythm of the
music.
Stand-by (35)
With this function the DMX1360 Controller is set to a stand-by mode. The programs keep on running, but
DMX output for conventional light is off. This function is almost the same as the "blackout" function for
moving light effects.