Beamz DMX1360 Instruction Manual page 9

9) AUDIO button
Used to activate audio sync of chase rate or set a scene at audio effect.
10) BLACKOUT button
Press this button to enable or disable relevant DMX output. When its LED is lit, that means relevant
DMX output is disabled. Press this button again the LED will be "off", that means the DMX output is
reactivated.
11) SETUP button
Press this button for about 3 seconds to access the SETUP menu.
12) FOG MACHINE button
This button is used to control the Fog machine. Relevant LED will show you the different working states
(HEATING or READY).
13) DEL button
Press this button to delete relevant Scenes or Chases.
14) LCD Display
15) RECORD button
Press and hold down this button for about 5 seconds to access the Scene/Chase mode, and also usethis
button to record Scenes or Chases.
16) ESC button
To cancel relevant operation or to exit.
17+18) UP/DOWN buttons
To select or adjust desired item or level during operation.
19) CH.PAGE button
Press this button to switch between CH 1-8 and CH 9-16. LED "off " means 1-8 channels available, while
LED "on " means 9-16 channels available.
20) Up button
Used to adjust PAN / TILT movement.
21) FINE button
Use this button can adjust relevant level finely by a small margin .
22) Left buttons
Used to adjust PAN / TILT movement.
23) Joystick
Used to control and adjust relevant level more conveniently through the Pan or Tilt movement.
24) Right button
Used to adjust PAN / TILT movement.
25) SPEED fader
Used to set or adjust relevant speed as user's desire.
26) FADE fader
Used to set or adjust relevant fade as user's desire.
27) Down button
Used to adjust PAN / TILT movement.
28) SCENE buttons
Press the scene buttons to load or store relevant Scenes.
29) AUTO button
Used to activate AUTO mode.
30) CHASE buttons
These buttons are used to load or store relevant Chases.
31) ONE/MIX/SEQ button
To select One mode, Mix mode or Sequence mode.