Using The Machine; End Of Use And Switching Off; Storing The Machine; Draining The Recovery Water - HAKO Scrubmaster B8 Instruction Manual

9.1.c - Using the machine (Fig. 18)
- After turning on the machine and choos-
ing the type of cycle, initiate the cleaning
operations by pressing and holding the
levers (4) or the lever (3); then turn off
the machine using the buttons (42) on the
handle bar (1).
NOTE:
By releasing the levers (4) or the lever (3),
the brush stops revolving and the water sup-
ply is cut off, while the vacuum cleaner will
operate for another 10 seconds.
NOTE:
In order not to damage the floor and to avoid
excessive water accumulations, do not use
the machine stopped with the revolving
brush attached.
- If needed, adjust the quantity of washing
water using the button (36).
- Check the battery charge status by
means of the LEDs (34) (battery version
only).
- If needed, adjust the ground pressure of
the brush by pressing the button (15).
9.1.d - End of use and switching off
(Fig. 18)
- At the end of the cleaning operations,
before turning off the machine, cut off
the water supply by pressing the relative
button, continue with the vacuum cleaner
and with the revolving brush attached in
order to vacuum the entire liquid from the
floor and from the brush, then release the
levers (4).
- Lift the brush assembly (9) by pressing
the pedal (10) until reaching the limit
switch securing it in the adequate slot.
WARNING:
Always lift the brush assembly at the end
of the cleaning operations in order to
avoid its deformation and of the rubber
blades.
- Press the button (30), the LED (31) turns
off.
- Disconnect the power supply cord from
the socket (charger version only).
9.1.e - Storing the machine (Fig. 19)
NOTE:
Before storing the machine, ensure that the
tanks (12) and (13) are empty.
The machine was designed to be stored in
confined spaces.
- Lower the handle bar (1), the machine
can be placed under a shelf or it can be
lifted vertically according to the drawing
in order to be placed between two furni-
ture pieces.
10.1 DRAINING THE
RECOVERY WATER
At the end of the washing cycle or when the
recovery water tank (13) is full, it is neces-
sary to empty the tank by proceeding as fol-
lows:
N.B.:
To dispose of the recovery water, comply
with the standards in force in the country in
which the machine is used.
- Lift the lid (11).
- Remove the tank (13) by lifting the ma-
chine using the handle bars (43).
- Place it on an drain valve and fully drain
the entire water from the tank.
- Clean the gasket (44) with a wet cloth.
- Clean the inside of the tank and replace it
on the machine, ensuring that the handle
bars (43) are withdrawn, as shown in the
figure.
ENGLISH - 11
(Fig. 20)