Sierra Wireless AirCard 595U User Manual page 26

9. Slide the lever on the bottom of the device in the direction indicated by the
triangle to release the device's USB connector.
10. Adjust the USB connector to the desired angle. (The USB connector is
adjustable to three positions—approximately 90, 135, and 160 degrees. Do
not force the hinge past the last position—this may break the connector.)
11. Insert the device into your computer's USB slot.
Alternatively, you can attach the docking station to your computer's USB slot,
and insert the device into the docking station.
Note: If your computer's USB slot is vertical, use the docking station.
Do not insert the device into a USB hub or a USB slot on a keyboard.
Warning: If the orientation of your computer's USB slot or the thickness of your
computer are such that pressure is applied to the device's end or side (as
shown by the red circles in the drawings below), you may damage the device
or your computer. In such cases, do not insert the device directly into your
computer's USB slot; use the docking station instead.
Windows detects the device and installs the drivers for it. This may take a few
minutes. Once completed, Sprint Connection Manager should display
"Disconnected." The PWR LED is lit.
12. Charge the battery for approximately two hours.
Note: If you have an older version of Sprint Connection Manager and are
experiencing problems during installation, use the Add/Remove Programs
Utility (see page 54) to remove the older version of Sprint Connection
Manager. Then reinstall the current version of Sprint Connection Manager
from the Installation CD.
18 Section 2A: Installing the Software