Sierra Wireless AirCard 595U User Manual page 25

To install the software on your computer:
1. If the installation CD is not already in your CD-ROM drive, insert it.
The CD should autostart.
If the CD does not autostart, select Start > Run and enter d:\SCMInstaller.exe,
where d is the drive letter of your CD-ROM drive.
2. Use the Next and Back buttons to navigate through the wizard, noting the
following:
You must select I accept the terms in the license agreement to indicate your
acceptance of the terms of the license agreement to proceed with the
installation.
Use the default settings for the Destination Folder unless you have special
requirements and an advanced understanding of PC configuration. (The
Destination Folder dictates where the software is installed.)
3. When the "Installation Complete!" window is displayed, click Finish.
4. Run Sprint Connection Manager.
(Double-click the program's icon [
5. Wait for Sprint Connection Manager to start up and display "No device...".
6. Slide the front panel off the Sprint Mobile Broadband USB modem.
7. Hold the battery so that the side with two white arrows faces up and the gold
contact points on the end of the battery line up with the gold contact points
on the Sprint Mobile Broadband USB modem. Insert the battery into the
device.
Warning: To avoid the risk of explosion, use the same battery model when replacing
the battery. Properly dispose of the used battery.
8. Slide the front panel onto the device until the panel clicks into place.
Section 2A: Installing the Software
] on your desktop.)
17