Changing The Feed/Pressure Rollers - ESAB Rebel EMP 205ic AC/DC Instruction Manual

5 OPERATION
5. The wire reel hub incorporates a friction brake which is adjusted during manufacture
for optimum braking. If it is considered necessary, adjustment can be made by turning
the thumb screw inside the open end of the hub clockwise to tighten the brake.
Correct adjustment will result in the wire reel circumference continuing no further than
1/8 in.-3/16 in. (3-5 mm) after release of the trigger. The electrode wire should be
slack without becoming dislodged from wire spool.
Checking for proper feed-roller pressure
5.10

Changing the feed/pressure rollers

NOTE!
Make sure not to lose the key that is located on the drive motor shaft. This key must
be in place and align with drive roll slot for proper operation.
Three dual groove feed roller are supplied as standard. Change the feed roller to match the
filler metal wire diameter.
0463 652 101 - 31 - © ESAB AB 2024