Operation Status - MUTOH ValueJet VJ-1604 Maintenance Manual

VJ-1604 Maintenance Manual
9.2.1

Operation Status

This section describes the message contents, check items, and recovery actions for normal operation.
Table 9-2 Events and Check Items for Operation Status Messages
No. Message
1 Cover open
2 Set media
Event/ Check item
symptom
Front cover is 1. Is cover sensor
open. assembly loose?
Media holding 1. Are front cover R
lever is turned sensor assembly
backward. cable and front
cover L sensor
assembly cable
connected securely?
2. Does pressure lever
move smoothly?
3. Is lever sensor
assembly fitted
correctly?
4. Is sensor of lever
sensor assembly
contaminated?
5. Is lever sensor
cable connected
securely?
6. Panel unit assembly
may be damaged.
7. Panel cable may be
damaged.
Tighten cover sensor
assembly screws.
Correctly connect front
cover R sensor
assembly cable to
MAIN board assembly
connector J38, and front
cover L sensor assembly
cable MAIN board
assembly connector J40.
Lubricate pressure cam.
Adjust lever sensor
assembly position.
Clean sensor face using
a swab.
Correctly connect lever
sensor assembly cables
to MAIN board
assembly connector J32.
Replace panel unit
assembly.
Replace panel cable.
9-3
9 Troubleshooting
Action Reference
"4.3.3
Replacing
Front Cover
Sensor" p.4-
32
"4.4.7
Replacing
MAIN
Board" p.4-
49
"8.5
Lubrication/
Bonding"
p.8-7
"4.6.6
Replacing
Lever Up
Sensor" p.4-
67
"4.6.6
Replacing
Lever Up
Sensor" p.4-
67
"4.6.6
Replacing
Lever Up
Sensor" p.4-
67
"4.3.1
Replacing
Panel Unit"
p.4-30
"4.3.1
Replacing
Panel Unit"
p.4-30
Rev.-00