Sub Controller Installation - MUTOH ValueJet VJ-1604 Maintenance Manual

VJ-1604 Maintenance Manual
4. When sending completes and the "Send
completed" window opens, click [OK].
NOTE
Almost as soon as the "Send completed" window is displayed, writing to plotter also finishes. If
writing to plotter finishes successfully, the LCD displays the following:
Transfer complete
Buzzer sounds three times and only Power LED turns on. Then, when the LCD displays
16372 bytes recv
parameter writing completes.
7.3.7

Sub Controller Installation

This section describes installation procedures of HEATER_CONT board firmware.
TIP
The extension of the sub controller file is .mfl.
1. Click [Sub Controller Install].
7-17
7 Adjustment
Rev.-00