Panasonic WV-CU650 Operating Instructions Manual page 97

■ Controlling Digital Disk
Recorder WJ-HD500 Series
The following are the operating procedures of WJ-HD500
Series via system controller.
Note: Refer to the operating instructions of Digital Disk
Recorder WJ-HD500 Series for details.
● Recorder Mode
Before operating the recorder, it is necessary to enter the
recorder mode.
1. Select the desired monitor. (Refer to p. 3 Monitor
Selection.)
2. To select a recorder, press the corresponding numeric
button.
Recorder
Master recorder 0 (You can skip pressing this button.)
Slave 1 recorder
Slave 2 recorder
Slave 3 recorder
Slave 4 recorder
3. Press the RECORDER/UNIT button. The system will
enter the recorder mode.
• The images from the recorder are displayed on the
active monitor in multiscreen segments.
• The camera number will disappear from the LCD.
• The monitor number, recorder number, and
"/ HD500" will appear on the LCD.
Mon4 Cam--
4. To exit the recorder mode, select the camera. (Refer to
p. 3 Camera Selection.) The monitor number and cam-
era number will appear on the LCD again.
You can also exit the recorder mode by pressing the
RECORDER/UNIT button during the recorder mode.
Note: Only one operator can enter the recorder mode.
Numeric button
1
2
3
4
R4
/HD500
● Multiscreen Segment Switching
Multiscreen segment patterns are configurable through WJ-
HD500 SETUP.
(Refer to the recorder's operating instructions.)
1. Enter the recorder mode. (Refer to Recorder Mode.)
2. Press the MULTI SCREEN button. Every time you press
the button, the multiscreen segment patterns are
switched. (The following is the factory default setting.)
4A (Page 1 of the quad → Camera 1, 2, 3, and 4) → 4B
(Page 2 - Camera 5, 6, 7 and 8) → 4C (Page 3 -
Camera 9, 10, 11 and 12) → 4D (Page 4 – Camera 13,
14, 15 and 16) → 7 (segments) → 9 →10 → 13 → 16 →
4A
3. To return to the spot display, exit the recorder mode.
Note: Multiscreen segment patterns are not configurable
through WJ-SX150A Administrator Console.
● Normal Playback
1. Enter the recorder mode. (Refer to Recorder Mode.)
2. To start the playback, press the PLAY/PAUSE button.
The system will enter the playback mode. Then, the
most recent recorded image will be played back.
• To pause the playback, press the PAUSE button.
• To stop the playback, press the STOP button.
• To resume the playback, press the PLAY/PAUSE button.
• To move forward/backward search during the play-
back, move the shuttle ring clockwise or counter-
clockwise.
Shuttle ring clockwise: Fast-forward playback
Shuttle ring counterclockwise: Rewind playback
Shuttle hold button: If you press this button while
rotating the shuttle ring, playback speed will be
maintained even after removing a hand from the
shuttle ring. (The LED indicator on this button
blinks during the fast playback.)
• To move forward/backward field advance during
the pause, move the JogDial clockwise or counter-
clockwise.
JogDial clockwise: Forward field advance
JogDial counterclockwise:
advance
Backward field
19