Panasonic WV-CU650 Operating Instructions Manual page 75

Problem
Buzzer sound is not heard.
You cannot activate any functions even
when pressing the A, B, or top button of
the 3D joystick unit.
"Controller No.1 No Exist Error" is dis-
played on the LCD.
You cannot activate any functions even
when pressing the function buttons (F1
to F4/F5 to F8).
When pressing one of the function but-
tons (F1 to F4/F5 to F8), there is a differ-
ence between the function displayed on
the LCD and that recalled actually.
There is an invalid button even when it is
pressed.
Operation is suddenly discontinued
while controlling system units.
"ALM SUSPEND" indicator light up or
goes out even when no system unit is
controlled.
The power cord insulation is damaged.
The power cord and the power plug of
the AC adapter are hot during use.
The power cord gets warm or hot if bent
or pulled during use.
Check item and Remedy
The buzzer may be set to OFF. Check
the setting.
The cable may be disconnected from
either the system controller and 3D joy-
stick. Check the connection.
Function assignment settings of the A, B
or top button may be wrong. Check the
settings.
Users who have logged into the system
may not be authorized to control cam-
eras with these buttons. Check the user
level settings of these users.
There may be no system controller set to
CONTROLLER NO. 1. A system controller
must be set to CONTROLLER NO.1.
Check the CONTROLLER NO. switch at
the rear panel of each system controller.
Function assignment settings of the F1 to
F8 buttons may be wrong. Check the
settings.
Users who have logged into the system
may not be authorized to control cam-
eras with these buttons. Check the user
level settings of these users.
Function assignment settings of the F1 to
F8 buttons may be wrong. Check the
settings.
The LCD title may have been edited
wrongly. Check the setting.
Can the selected monitor, camera, or
system unit activate the function
assigned to the button? Depending on
system devices, available functions will
differ. Refer to the operating instructions
of selected system unit.
Users who have logged into the system
may not be authorized to control cam-
eras with the button. Check the user
level settings of these users.
There may be a user controlling system
units from another system controller.
Check that no users are controlling other
system controllers.
The power cord or the plug is damaged.
If you continue to use it, a fire or an elec-
tric shock may occur. Unplug the AC
adapter immediately, and refer servicing
to qualified service personnel.
Reference
Refer to pp. 28 or 29.
Refer to p. 17.
Refer to pp. 53 and 54.
Refer to pp. 62 to 65.
Refer to p. 18.
Refer to pp. 52 to 54.
Refer to pp. 62 to 65.
Refer to pp. 52 to 54.
Refer to p. 68.
—
Refer to pp. 62 to 65.
—
—
—
—
75