Panasonic WV-CU650 Operating Instructions Manual page 112

TIME-LAPSE VCR CONTROL
A time-lapse VCR (Panasonic Models) is operable with the
system controller, while connecting to the matrix switcher.
Note: Before the use, it is necessary to install the
Multiplexer board in the matrix switcher, connect
the matrix switcher to the time-lapse VCR, and con-
figure the system through WJ-SX150A Administrator
Console, OSD SETUP MENU, and time-lapse VCR's
SETUP MENU. (Refer to the operating instructions
of matrix switcher.)
The following is the procedure of a Panasonic model time-
lapse VCR.
■ Controlling the Time-lapse VCR
The following are the operating procedures of the time-
lapse VCR via system controllers.
● Multiscreen Segment Switching
The operations are the same as WJ-HD500 Series.
(Refer to p. 18.)
Note: 7-, 10-, and 13- segment multiscreen display pat-
terns are unavailable.
● Normal Playback
The operations are the same as WJ-HD500 Series.
(Refer to p. 19.)
Note: You cannot skip to the previous/next record.
● Fast-forward
1. Move the shuttle ring clockwise to fast-forward the tape
during the stop.
2. To stop fast-forwarding, press the STOP button.
Note: Pressing the PLAY/PAUSE button during fast-for-
ward will start playback.
34
[PANASONIC MODELS] (TERMINAL MODE)
MUX
● Rewind
1. During the stop, move the shuttle ring counterclockwise
to rewind the tape.
2. Press the STOP button to stop rewinding.
Note: Pressing the PLAY/PAUSE button during rewind
will start playback.
● Manual Recording
The operations are the same as WJ-HD500 Series.
Refer to p. 20 Manual Recording.
● Stopping REC ONLY Alarm
Recording
The operations are the same as WJ-HD500 Series. Refer to
p. 20.