LifeFitness 9100 Service Manual page 99

Life Fitness Models 9100, 9500HR, 9700HR, and 9700HR w/Decline Treadmills
How To...CLEAN THE WAX NOZZLE
Tools Required: Phillips screwdriver, medium-to-soft bristle brush, and hot water
Step 1
Turn the unit power OFF at the switch, then unplug
the line cord at the wall outlet.
Step 2
Using a Phillips screwdriver, remove the two(2)
screws from the access panel on the right side of the
unit.
Step 3
Carefully reach inside the unit and locate the wax
nozzle. Push the tip of the wax nozzle inward and
rotate the nozzle 1/4 turn in a clockwise rotation and
remove the nozzle. Note the two(2) flats on the wax
nozzle. These flats must be at a horizontal plane
upon final installation.
Step 4
Place the nozzle in a container of
hot water and let sit for at least 10
minutes or when water has cooled
enough to the touch.
Step 5
Remove the nozzle from the water
and inspect for cleanliness. If
necessary, scrub-clean with a
medium-to-soft bristle brush to
remove any wax residue from
outside and inside the wax nozzle.
Step 6
Dry the nozzle off with a lint-free
rag.
Step 7
Reinstall the wax nozzle into its
holder and while pressing in, rotate
the nozzle 1/4 turn counterclockwise.
IMPORTANT: MAKE ABSOLUTELY SURE, THAT UPON FINAL ASSEMBLY, THE FLATS ON THE WAX
NOZZLE ARE POSITIONED IN A HORIZONTAL PLANE. FAILURE TO DO SO WILL RESULT IN IMPROPER
WAX APPLICATION.
34
Access
Cover
To Install -
Rotate ¼ turn
Wax Nozzle
counter-clockwise
Holder
Wax Nozzle
Wax Nozzle
Cover
Screws
Nozzle Flats must
be in a Horizontal
plan for final assembly
To Remove -
Rotate ¼ turn
clockwise
Push in and
rotate for
installation
or removal