Related Manuals for LifeFitness CST
Summary of Contents for LifeFitness CST
- Page 1 INTEGRITY AND CLUB SERIES TREADMILLS CST, CLST & 97TI ASSEMBLY INSTRUCTIONS M051-00K58-0379 REV. E...
-
Page 2: Important Safety Instructions
Congratulations... and welcome to the world of The following Component Lists and the step-by-step assembly procedures have been assembled to make the set-up of this treadmill as quick and easy as possible. Please take special note of the following important points prior to choosing a location and beginning assembly of the treadmill. -
Page 3: Component List
COMPONENT LIST Part Description Qty. Part Description Qty. Left upright Right upright Handlebar (left and right) Ergo™ front crossbar Left inside handlebar shroud Right inside handlebar shroud Left outside handlebar shroud Right outside handlebar shroud Lower upright cover (left and right) Display console 0017-00101-1265 Left accessory tray... - Page 4 HARDWARE SCREW GROMMET (#18) HANDLEBAR SHROUD SCREW (#15) FRONT CROSSBAR NUT (#22) ENDCAP / UPRIGHT COVER SCREW (#16) UPRIGHT WASHER (#24) LINECORD CLIP (#23) DISPLAY CONSOLE / HANDLEBAR SUPPORT SCREW (#17) FRONT CROSSBAR SCREW (#19) UPRIGHT MOUNTING BOLT (#20) ACCESSORY TRAY SCREW (#21)
- Page 5 IMPORTANT DO NOT DISCARD THE SHIP KIT LOCATED ON TOP OF THE DECK AND BELT. ALL NECESSARY COMPONENTS NEEDED TO COMPLETE THE INSTALLATION ARE LOCATED IN THE SHIP KIT. NE JETEZ PAS LE KIT D'EXPÉDITION PLACÉ SUR LE DESSUS DU PLATEAU ET SUR LE TAPIS. IL CONTIENT TOUS LES ÉLÉMENTS NÉCESSAIRES POUR L'INSTALLATION.
- Page 6 6. With the bend of one H (3) directed to the ANDLEBAR outside of the treadmill, insert the H into ANDLEBAR the R (L) as IGHT PRIGHT ANDLEBAR RACKET shown. Be sure the handlebar mounting holes are aligned. Repeat for the left side H ANDLEBAR 7.
- Page 7 11. Slide the L (5) near the NSIDE ANDLEBAR HROUD (N). PRIGHT ANDLEBAR RACKET Locate and position the L UTSIDE ANDLEBAR (7) to match the L HROUD NSIDE ANDLEBAR HROUD Secure the S together using three S HROUDS CREWS (15). Tighten the S securely.
- Page 8 15. Locate the L (11). Carefully slide the tray into CCESSORY the top of the L (1) as shown until fully seated. PRIGHT Secure the accessory tray to the L OUNTING LATE using four S (21). Repeat the procedure for the R CREWS IGHT (12) and R...
-
Page 9: Physical Dimensions
IMPORTANT CHECK THE BELT EDGE UNDER THE TREADMILL TO VERIFY THE BELT DOES NOT INTERFERE WITH LIFE- SPRING BRACKETS AND THE BELT IS PROPERLY SET WITHIN THE BELT GUIDES. PHYSICAL DIMENSIONS: WEIGHT LBS (KG) STEP UP HEIGHT PHYSICAL DIMENSIONS INCHES (CM) MODEL LOW VOLTAGE HIGH VOLTAGE INCHES...