LifeFitness 9100 Service Manual page 92

Life Fitness Models 9100, 9500HR, 9700HR, and 9700HR w/Decline Treadmills
How To... Replace The Main Wire Harness
Tools Required:
Step 1
Turn the unit power OFF at the switch,
then unplug the line cord at the wall
outlet.
Step 2
Remove eight screws from the back of
the console.
Step 3
Disconnect all cable connectors from
the circuit board.
Step 4
Remove six mounting screws securing
the display console to the TUBE
EXTENSIONS, then
display console.
Step 5
Remove the left TUBE EXTENSION
from the cables, routing out the cables
from the tube.
Step 6
Remove the eight screws from the HANDLE
BAR, and remove the handle bar.
Step 7
Remove the MOTOR SHIELD and disconnect
the MAIN WIRING HARNESS CONNECTOR
from the WAX LIFT BOARD.
Step 8
Remove three mounting bolts at the base of the
left handrail support.
Step 9
Lift off the left handrail while routing out the
cable from the frame.
Step 10
Remove the LEFT HANDLE BAR END CAP and
route out the MAIN WIRING HARNESS and
discard.
Step 11
Install new wire harness in reverse order. With
the left handle bar end cap removed, first route
the cable out the end of the handle bar, then re-
route back.
remove the
Cable
Routing
10-P
Connector
27