Network Setup; Intranet/Lan Access Setup - KGuard Security KG-SHA104 User Manual

5.2.6. Network Setup

5.2.6.1. Intranet/LAN Access Setup

If your DVR is connected to a router of your LAN (local area network), then you can setup the
NETWORK Setup section of the DVR to view the image your DVR is recording remotely using
computers connected within your LAN.
Note: Prior to changing the NETWORK Setup of your DVR, it is strongly recommended that you
perform the following tasks:
1. Access the configuration page of your router.
2. Reserve an IP Address in your router that is not used by other computers or devices connected to
your internal network.
3. Write down the assigned IP Address of your DVR, Subnet Mask, IP Address of the router
(Gateway) your DVR connect to for future reference.
G. Enter the DNS (Domain Name Server) Address; set this to you router's IP address.
H. Click "APPLY" to save your change.
Your DVR supports to be remotely accessed via
network, so that you can remotely control the
DVR for monitoring, recording, playing back or
making backup. Prior to the remote access, you
need to set the network configuration at MAIN
MENU  NETWORK interface.
A. Select STATIC as the network TYPE.
B. Setup PORT (media port)
C. Input the WEB PORT (Must be different from
media PORT)
D. Enter the IP Address that you have reserved at the
beginning of this section into this field to be the
unique address of your DVR in your local network.
E. NETMASK: It is recommended to leave the
Subnet mask as the default 255.255.255.0.
F. Set the GATEWAY to the IP Address of your
router.
23