Ice Machine Installation Options - Manitowoc S Model Installation, Use & Care Manual

Installation Instructions
General
These instructions are provided to assist the qualified
installer. Check your local Yellow Pages for the name of
the nearest Manitowoc distributor, or call Manitowoc Ice,
Inc. for information regarding installation and start-up
services.
Failure to follow these installation guidelines may
affect warranty coverage.
PERSONAL INJURY POTENTIAL
Remove all ice machine panels before lifting and
installing.

Ice Machine Installation Options

CVD1486 CONDENSER WATER PRESSURE
Water pressure at the condenser cannot exceed 150
psig (10.34 bar) with the standard water-regulating
valve. Contact your distributor if your water pressure is
greater than 150 psig (10.34 bar). A special order
condensing unit is available that allows water pressure
up to 350 psig (24.13 bar).
ICE MACHINE HEAD SECTIONS
The ice machine head can be installed with the electrical
inlet, water supply inlet and refrigeration tubing entering
from the back or top of the ice machine.
The ice machine water drain must exit the back of the
ice machine.
TUBING CAN BE ROUTED
OUT BACK OR TOP
2-6
Important
! Warning
TUBING CAN BE
ROUTED OUT TOP
TRIM TOP PANEL WHEN
EXITING TOP
Cut the top cover for top routing of electrical inlet, water
supply inlet or refrigeration lines.
1. Prior to cutting, mount top cover onto ice machine.
2. Use ice machine back panel recessed area as a
template to mark the underside of the top cover.
Do not cut up to or past this line!
3. Using an aviator snips, cut top cover as needed:
A. Do not cut out entire area! Cut up to 1/8 inch to
marked line.
B. Cut out only what is needed. (If routing only
refrigeration lines out the top, cut just enough to
route these lines.)
SV1752
C. Do not cut out the entire corner area.
Section 2
TUBING CAN BE
ROUTED OUT
BACK OF THE ICE
MACHINE WITH
PROVIDED 90
ELL'S
S1470C
TRIM TOP COVER
IN THIS AREA
Part Number 000002477 3/08
°