Changing The Encoder Settings - FARGO electronics DTC500 Series Troubleshooting Manual

RESTRICTED USE ONLY

Changing the Encoder Settings

Use this option to choose the settings that coincide with the Printer's current encoding
configuration. Use the scroll buttons to select the option (you want to change).
Step Procedure
1 Select MENU, Setup Printer, and Encoder Settings.
2 Change the desired option as needed.
•
Mag: Press the CHANGE button to select None or Installed according to
whether or not a Magnetic Stripe Encoder is installed.
•
Smart: Press the CHANGE button to select None or Installed according to
whether or not a Smart Card Encoder is installed.
•
Prox: Press the CHANGE button to select None or Installed according to
whether or not a Prox Card Encoder is installed.
•
Position: This option is set according to the card size for which your Encoder
is physically positioned inside the Printer. (Note: All DTC500 Series Printers
are configured only for CR-80 size cards.)
Do not change this setting.
3 Press SAVE to save the value.
DTC500 Series Card Printer/Encoders Troubleshooting Guide (Rev. 3.0)
FARGO Electronics, Inc.
201