Paging Zone - VTech VSP735 Administrator And Provisioning Manual

Internal Ringer Tone

Paging Zone

On the Paging Zone page, you can enter the multicast IP addresses that the phone
will monitor. When a page is sent out using this multicast IP address, all phones that
are programmed to monitor that IP address will receive the paging RTP stream and
play the page on their speakerphone. You can also enable the phone to send out
multicast pages using a particular multicast IP address.
You must first set up paging groups (each group consisting of a multicast paging IP
address and assigned User IDs) on your SIP PBX. The deskset can monitor a
maximum of 10 multicast IP addresses.
Setting
Name
Multicast IP
Multicast Port
Priority
VSP735 Administrator and Provisioning Manual
Select the desired ringer from the list.
Description
Enter the name of the paging zone. Names can be a maximum
of 15 characters. The paging zone name is displayed on the
LCD during incoming and outgoing multicast pages.
Enter the paging zone multicast IP address. The IP address
range for multicast addresses is 224.0.0.0–239.255.255.255.
Enter the multicast port used by the multicast IP address. The
valid port range is 1 to 65535.
Select the paging zone priority from 1 to 10. Zones with a
priority higher than another zone can interrupt the lower-
priority zone's active page.
In addition, a call priority setting is available in the
configuration file (page_zone.call_priority_threshold). This
priority setting also ranges from 1 to 10. If the paging zone
priority is higher or equal to the call priority, then a multicast
page can interrupt an active, dialing, or incoming call.
52 WebUI: System