VTech VSP735 Administrator And Provisioning Manual page 22

 DHCP
 Set static IP
 VLAN ID
 Others (DNS and NTP servers).
To enable or disable DHCP:
1. From the Network setting menu, press  or  to highlight DHCP, and then press
SELECT.
2. Press  or  to select Enabled or Disabled, and then press Save.
DHCP is enabled by default, which means the deskset will get its IP address from the
network. When DHCP is disabled, you must enter a static IP address for the deskset.
NOTE: You must be familiar with TCP/IP principles and protocols to configure static
IP settings.
To set static IP for the deskset:
1. From the Network setting menu, press  or  to highlight Set static IP, and
then press SELECT.
If DHCP is disabled, the Set static IP menu appears. If DHCP is enabled, an
error message appears briefly before returning you to the Network setting menu.
2. On the Set static IP menu, enter the static IP address. Use the dial pad and the
Add dot soft key to enter characters. Press  or  to advance to the next
character.
Set static IP
IP:
Subnet Mask:
Gateway:
Cancel Backspc
3. Press  and enter the Subnet Mask. Use the dial pad and the
enter characters. Press  or  to advance to the next character.
4. Press  and enter the Gateway. Use the dial pad and the
enter characters. Press  or  to advance to the next character.
5. Press Save.
To set the VLAN ID for the deskset:
1. From the Network setting menu, press  or  to highlight VLAN ID, and then
press SELECT.
2. On the VLAN ID menu, press  or  to enable or disable the WAN VLan.
0.0.0.0
0.0.0.0
0.0.0.0
Add dot Save
22
VSP735 Administrator and Provisioning Manual
Add dot
Add dot soft key to
soft key to
Using the Phone Menu