Base Settings; Dial Type; Change The Dial Mode; Change The System Pin Code - VTech VT1012 User Manual

Base Settings

Dial Type ( Preset to TONE )

Change the dial mode

• If the new
1. Press left soft key
PIN entered
2. Press OK and
in Step 6 is
not matched
3. Press OK and
with the new
4. Press OK to confirm.
system PIN

Change the system PIN Code

entered in
Step.
A 4-digit system PIN code is used for changing the system settings of the base station. It is used to protect your
phone against unauthorized use. The default system PIN code is 0000.
• If there is
1. Press left soft key
an incoming
2. Press OK and
call during
3. Press OK and you are requested to enter the 4-digit system PIN.
paging, the
4. Enter the old system PIN.
phone will
5. Press OK and enter the new system PIN.
ring with the
incoming call
6. Press OK and enter the new system PIN again.
instead of
7. Press OK to confirm.
paging.

Paging (Find the Handset)

You can locate the handset by pressing
produce the paging tone and "PAGING..." is displayed on the LCD. You can stop the paging by pressing
any handset or
17
and / to select BS SETTINGS.
/ to select DIAL MODE.
/ to select TONE or PULSE.
and / to select BS SETTINGS.
/ to select CHANGE PIN.
on the base station.
on the base again.
www.vtech.com
All the handsets registered to the base will
on