Network; Basic Network Settings - VTech VSP735 Administrator And Provisioning Manual

Network

You can set up the phone for your network configuration on the Network settings
page. Your service provider may require you to configure your network to be
compatible with its service, and the phone settings must match the network settings.
The network settings are also available as parameters in the configuration file. See
"network" Module: Network Settings on page 109.
After entering information on this page, click

Basic Network Settings

NOTE: If you disable DHCP on this page, you must configure static IP settings for
the phone. You must be familiar with TCP/IP principles and protocols to configure
static IP settings.
Basic Network Settings
Click the link for each setting to see the matching configuration file parameter in
Appendix A: Configuration File Settings. Default values and ranges are listed there.
Setting
Enable DHCP
IP Address
Subnet Mask
Gateway
Primary DNS
Secondary DNS
Description
DHCP is selected (enabled) by default, which means the deskset will
get its IP address, Subnet Mask, Gateway, and DNS Server(s) from
the network. When DHCP is disabled, you must enter a static IP
address for the deskset, as well as addresses for the Subnet Mask,
Gateway, and DNS Server(s).
If DHCP is disabled, enter a static IP address for the deskset.
Enter the subnet mask.
Enter the address of the default gateway (in this case, your
router).
If DHCP is disabled or you don't wish to use the DHCP-assigned
DNS server (or one specified by your service provider), enter
addresses for the primary and secondary DNS servers.
VSP735 Administrator and Provisioning Manual
to save it.
54 Network