VTech VSP735 Administrator And Provisioning Manual page 31

Authentication name
Authentication password
Dial Plan
Inter Digit Timeout (secs)
Maximum Number of Calls
Page Auto Answer
Feature Synchronization
Line Type
Barge-in
DTMF method
Unregister after reboot
VSP735 Administrator and Provisioning Manual
If authentication is enabled on the server, enter the
authentication name (or authentication ID) for
authentication with the server.
If authentication is enabled on the server, enter the
authentication password for authentication with the server.
Enter the dial plan, with dialing strings separated by a |
symbol. See Dial Plan on page 32.
Sets how long the phone waits after any "P" (pause) in
the dial string or in the dial plan.
Select the maximum number of concurrent active calls
allowed for that account.
When set to Auto, enables the deskset to automatically
answer when a page is received. This is usually the desired
behavior for paging.
Enables the phone to synchronize with Broadworks
Application Server. Changes to features such as DND, Call
Forward All, Call Forward No Answer, and Call Forward
Busy on the server side will also update the settings on
the phone menu and WebUI. Similarly, changes using the
phone or WebUI will update the settings on the server.
Select the line type to Private or Shared. A private line will
be accessible only at the deskset you are configuring.
Shared lines can be assigned to more than one deskset. For
more information about using shared lines, see the VSP735
Deskset User Guide.
Enables subscribers to shared lines to "barge in" on active
calls on other shared lines.
Select the default DTMF transmission method. You may
need to adjust this if call quality problems are triggering
unwanted DTMF tones or you have problems sending
DTMF tones in general.
Enables the phone to unregister the account(s) after
rebooting—before the account(s) register again as the
phone starts up. If other phones that share the same
account(s) unregister unexpectedly in tandem with the
rebooting deskset, disable this setting.
31 WebUI: System