Arctic Cat 2008 300 DVX Owner's Manual page 88

Headlight
n n
NOTE: NOTE:
The bulb portion of the headlight is fragile. HANDLE WITH The bulb portion of the headlight is fragile. HANDLE WITH
CARE. When replacing the headlight bulb, do not touch the glass CARE. When replacing the headlight bulb, do not touch the glass
portion of the bulb. If the glass is touched, it must be cleaned portion of the bulb. If the glass is touched, it must be cleaned
with a dry cloth before installing. Skin oil residue on the bulb will with a dry cloth before installing. Skin oil residue on the bulb will
shorten the life of the bulb. shorten the life of the bulb.
Do not attempt to remove the bulb when it is hot. Severe burns may
result.
To replace the headlight bulb, use the following procedure:
1. Remove the three-wire connector from the bulb; then
remove the rubber boot from the back of the headlight
housing.
2. Release the end of the spring clip from the headlight hous-
ing taking care not to bend or deform the clip; then remove
the bulb from the housing.
3. Install the new bulb into the housing; then secure with
the spring clip.
4. Install the rubber boot; then connect the three-wire connec-
tor to the bulb.
When replacing the headlight bulb, be careful not to touch the glass
portion of the bulb. Grasp the new bulb with a clean cloth.
Taillight/Brake light
To replace the taillight/brake light bulb, use the following procedure.
! WARNING
! CAUTION
1. Remove the two screws and
remove the lens.
2. Push the bulb in and turn it
counterclockwise.
3. Install the new bulb by turning it
clockwise while pushing in.
4. Install the lens. Tighten the two
screws securely.
KM143B
87