Arctic Cat 2008 300 DVX Owner's Manual page 65

Headlight LI/LO/HI Switch
When the switch is in the LIGHT position, the front and rear position
lights and the will illuminate.
Electric Starter Button
Pushing in on this button activates the starter motor. Before starting
the engine, make sure the ignition switch is in the ON position, the
transmission is in neutral, and the parking brake lock is engaged.
Choke Lever
The choke lever is used to help start a cold engine. Move the lever
to the left to activate the choke. Return the lever to the right position
to de-activate the choke.
Throttle Lever
by adjusting the throttle limiter screw. The throttle limiter should be
adjusted according to the operator's skill and experience.
64
Use the headlight LI/LO/HI switch
to select the high or low headlight
beam when the ignition switch is
in the LIGHTS position. When the
switch is in the HI position, the
high beam will illuminate. When
the switch is in the LO position, the
low beam will illuminate.
Control engine RPM with the
position of the throttle lever.
Operate this lever with the thumb.
Pushing it forward increases
engine RPM and allowing it to
retract decreases engine RPM.
Throttle lever travel may be limited
To adjust the throttle limiter, use
the following procedure:
1. Loosen the jam nut (1).
2. Turn the throttle limiter screw (2)
clockwise to decrease engine
RPM maximum or counterclock-
wise to increase engine RPM
maximum.
3. Tighten the jam nut securely.