Battery - Arctic Cat 2008 300 DVX Owner's Manual

Ball Joint Boots
(Upper and Lower/Right and Left)
1. Secure the ATV on a support stand to elevate the front wheels.
2. Remove both front wheels.
contact an authorized Arctic Cat ATV dealer for service.
Tie Rod Boots
(Inner and Outer/Right and Left)
1. Secure the ATV on a support stand to elevate the front wheels.
2. Remove both front wheels.
3. Inspect the four tie rod boots for cracks, tears, or perforations.
4. Check the tie rod end free-play by grasping the tie rod near the
end and attempting to move it up and down.

BATTERY

The battery is located under the seat.
The battery in this ATV is a "sealed" type and does not require any
maintenance unless discharged. Distilled water and/or electrolyte
cannot be added to the battery.
Anytime service is performed on a battery, the following must be
observed: Keep sparks, open fl ame, cigarettes, or any other fl ame
away. Always wear safety glasses. Protect skin and clothing when
handling batteries. When servicing battery in enclosed space, keep
the area well-ventilated.
78
3. Inspect the four ball joint boots
for cracks, tears, or perforations.
4. Check the ball joint for free-play
by grasping the steering knuckle
and turning it from side to side
and up and down.
5. If boot damage is present or ball
joint free-play seems excessive,
5. If boot damage is present or tie
rod end free-play seems
excessive, contact an
authorized Arctic Cat ATV dealer
for service.
! WARNING