Preparation After Storage - Arctic Cat 2008 300 DVX Owner's Manual

This maintenance-free battery requires periodic charging to
prevent sulfi ding. If the ATV will be idle for extended periods of time,
either run the engine or trickle charge every 30 days. If the battery
completely discharges, permanent damage will occur requiring
replacement.
10. Store the ATV indoors in a level position.
Avoid storing outside in direct sunlight and avoid using a plastic
cover as moisture will collect on the ATV causing rusting.
PREPARATION ATFTER STORAGE
Taking the ATV out of storage and correctly preparing it will assure
many miles and hours of trouble-free riding. Arctic Cat recommends
the following procedure to prepare the ATV.
1. Clean the ATV thoroughly.
2. Clean the engine. Remove the cloth from the exhaust system.
3. Check all control wires and cables for signs of wear or fraying.
Replace if necessary.
4. Change the engine oil and fi lter.
5. Check the coolant level and add properly mixed coolant as
necessary.
6. Charge the battery; then install. Connect the battery cables
making sure to connect the positive cable fi rst.
7 . Check the entire brake systems (fl uid level, pads, etc.), all
controls, headlights, taillight, brake light, and headlight aim; adjust
or replace if necessary.
8. Check the tire pressure. Infl ate to recommended pressure as
necessary.
9. Tighten all nuts, bolts, cap screws, and screws making sure all
calibrated nuts, cap screws, and bolts are tightened to speci-
fi cations.
10. Make sure the steering moves freely and does not bind.
11. Check the spark plug. Clean or replace as necessary.
12. Follow the recommendations found in the Starting the Engine
sub-section in Division I of this manual.
90
! CAUTION
! CAUTION