Protective Rubber Boots - Arctic Cat 2008 300 DVX Owner's Manual

Be careful not to spill any fl uid when fi lling the brake fl uid
reservoir. Wipe away spilled fl uid immediately.
Brake Hoses
Carefully inspect the hydraulic brake hoses for cracks or other
damage. If found, take the ATV to an authorized Arctic Cat ATV dealer
to have the brake hoses replaced.
Brake Pads
The clearance between the brake pads and brake discs is adjusted
automatically as the brake pads wear. The only maintenance that is
required is replacement of the brake pads when they show excessive
wear. Check the condition of each of the brake pads as follows:
Brake Lever Lock
Check to make sure the brake lever lock engages properly and that
the brake (when engaged) locks the rear wheels.

PROTECTIVE RUBBER BOOTS

The protective boots should be inspected periodically according to the
Maintenance Schedule.
! CAUTION
1. Remove a front wheel.
2. Measure the thickness of each
brake pad.
3. If thickness of either brake pad
is less than 2.0 mm (0.078 in.),
take the ATV to an authorized
Arctic Cat ATV dealer to have
brake pads replaced.
1. Engage the brake lever lock.
2. Attempt to push the ATV.
n
Note:
The brake lever lock must lock the
rear wheels. If it doesn't, take the
ATV to an authorized Arctic Cat
ATV dealer for service.
77