Arctic Cat 2008 300 DVX Owner's Manual page 62

ON position - The ignition circuit is complete and the engine can run.
The key cannot be removed in this position.
LIGHTS position - The ignition circuit is complete and the position
lights are on. The key cannot be removed in this position.
n
Note:
To illuminate the headlight, the engine must be running and the
headlight switch must be in the HI or LO position.
Leaving the ignition switch in the LIGHTS position for a long period
of time when the engine is not running may cause the battery to
discharge. Always leave the ignition switch in the OFF position
when engine is not running.
Indicator Lights
A. Indicator left/right
1. Temperature Indicator - A red light will illuminate if the engine
overheats. The light should be off during normal operation.
Continued operation of the ATV with high engine temperature may
result in engine damage or premature wear.
n
Note:
High engine RPM, low vehicle speed, or heavy load can raise engine
temperature. Decreasing engine RPM, reducing load, and selecting
an appropriate transmission gear can lower the temperature.
n
Note:
Debris in front of the engine (or packed between the cooling fi ns of the
radiator) can reduce cooling capability. Using a hose, pressure-wash
the radiator and the engine to remove any debris restricting air fl ow.
! CAUTION
! CAUTION
KM176A
61