Installing The Sn 5428 Chassis; Installing On A Table Or A Shelf - Cisco SN 5428 Hardware Installation

Storage router

Hide thumbs Also See for SN 5428:

Table of Contents

Installing the SN 5428 Chassis

Step 1

Step 2

Step 3

Cisco SN 5428 Storage Router Hardware Installation Guide

2-6

You can install the SN 5428 chassis on a table or a shelf, or in an equipment rack.

The following sections describe the steps required to install the SN 5428 chassis:

Installing on a Table or a Shelf, page 2-6

•

Rack-Mounting the SN 5428 Storage Router, page 2-7

•

Attaching the Optional Cable Guide, page 2-10

•

Before installing the storage router, read the Site Preparation and Safety Guide to

familiarize yourself with proper site and environmental conditions.

You can install the SN 5428 Storage Router chassis on a table or a shelf (or

another flat, secure surface).

If you are going to install the SN 5428 Storage Router in an equipment rack, skip

this section and proceed to the

section on page

2-7. To install the chassis on a table or a shelf, follow these steps:

Locate the four adhesive-backed rubber feet. They are in the accessory kit that is

shipped with the storage router.

Peel the rubber feet from their backing and place the feet, adhesive-side down,

onto the four round recessed areas on the bottom of the chassis.

Place the storage router on a table or a shelf near an AC power source.

Chapter 2

Installing the SN 5428 Storage Router

"Rack-Mounting the SN 5428 Storage Router"

OL-4796-01

Table of Contents