Cisco SN 5428 Hardware Installation page 29

Chapter 2 Installing the SN 5428 Storage Router
The plug-socket combination must be accessible at all times because it serves
Warning
as the main disconnecting device. To see translated versions of the warning,
refer to the Regulatory Compliance and Safety document that accompanied the
device.
This product relies on the building's installation for short-circuit (overcurrent)
Warning
protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S.
(240 VAC, 10A international) is used on the phase conductors (all
current-carrying conductors). To see translated versions of the warning, refer
to the Regulatory Compliance and Safety document that accompanied the
device.
Warning When installing the unit, the ground connection must always be made first and
disconnected last. To see translated versions of the warning, refer to the
Regulatory Compliance and Safety document that accompanied the device.
This equipment is intended to be grounded. Ensure that the host is connected to
Warning
earth ground during normal use. To see translated versions of the warning, refer
to the Regulatory Compliance and Safety document that accompanied the
device.
Never defeat the ground conductor or operate the equipment in the absence of
Warning
a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable
grounding is available. To see translated versions of the warning, refer to the
Regulatory Compliance and Safety document that accompanied the device.
During this procedure, wear grounding wrist straps to avoid ESD damage to the
Warning
card. Do not directly touch the backplane with your hand or any metal tool, or
you could shock yourself. To see translated versions of the warning, refer to the
Regulatory Compliance and Safety document that accompanied the device.
OL-4796-01
Cisco SN 5428 Storage Router Hardware Installation Guide
Read Safety Notices
2-3