Bale Clasp Sfp Modules - Cisco SN 5428 Hardware Installation

Chapter 2 Installing the SN 5428 Storage Router
To remove a bale clasp SFP module from a port, perform the following steps:
Open the bale clasp on the SFP module with your index finger in a downward
Step 1
direction as shown in
use your index finger to open it, use a small, flat-blade screwdriver or other long,
narrow instrument to open the bale clasp as shown in
Grasp the SFP module between your thumb and index finger and carefully remove
Step 2
it from the port as shown in
Figure 2-15 Removing a Bale Clasp SFP Module with Your Index Finger
OL-4796-01
Figure 2-15. If the bale clasp is obstructed and you cannot
Figure 2-15.
Cisco SN 5428 Storage Router Hardware Installation Guide
Installing SFP Modules
Figure 2-16.
2-19