Installing The Sn 5428 Storage Router - Cisco SN 5428 Hardware Installation

Installing the SN 5428 Storage Router

This chapter describes how to prepare your site for installation, how to prepare
and install the SN 5428 Storage Router chassis, how to connect network and Fibre
Channel cables, how to connect power, and how to verify correct installation. For
first-time installations, perform the procedures in the following sections in the
order listed here:
•
•
•
•
•
•
•
•
•
•
Warning Before you install, operate, or service the system, read the Site Preparation and
Safety Guide. This guide contains important safety information you should know
before working with the system. To see translated versions of the warning,
refer to the Regulatory Compliance and Safety document that accompanied the
device.
OL-4796-01
Read Safety Notices, page 2-2
Site Planning, page 2-5
Installing the SN 5428 Chassis, page 2-6
Installing SFP Modules, page 2-11
Connecting to Gigabit Ethernet and Fibre Channel Ports, page 2-20
Connecting to the 10/100 Ethernet Management and HA Ports, page 2-23
Connecting to the Console Port, page 2-24
Connecting Power, page 2-25
Verifying Installation, page 2-27
Where to Go Next, page 2-29
Cisco SN 5428 Storage Router Hardware Installation Guide
C H A P T E R
2
2-1