Appendix 2 Port Map - HIKVISION NETWORK CAMERA User Manual

46
User Manual of Network Camera

Appendix 2 Port Map

Note: The following setting is about TP-LINK router (TL-R410), which is maybe distinct from other router's
setting.
1. Firstly, select the router's WAN connection Type. As the following Fig. shows:
2. Set the "network parameter" of the router as the below figure. The setting includes subnet mask and gateway.
3. Set the port map in the virtual severs of Forwarding. By default, camera uses port 80, 8000, 554 and 8200. You
can change these ports value with IE or client software.
The following figure gives the illustration. One camera's ports are 80, 8000, 554, 8200 and its IP address is
192.168.1.23. The other camera's ports are 81, 8001, 555, 8201 and IP is 192.168.1.24. Afterwards, enable all or
TCP protocols. Enable the port map after pressing the 'Save'.
46