Appendix 2 Port Map - HIKVISION Network Camera User Manual

Hide thumbs Also See for Network Camera:

Table of Contents

User Manual of Network Camera

Note: The following setting is about TP‐LINK router (TL‐R410), which is maybe distinct from other

router's setting.

1. Firstly, select the router's WAN connection Type. As the following Figure shows:

2. Set the "network parameter" of the router as the below figure. The setting includes subnet

mask and gateway.

3. Set the port map in the virtual severs of Forwarding. By default, camera uses port 80, 8000, 554

and 8200. You can change these ports value with IE or client software.

The following figure gives the illustration. One camera's ports are 80, 8000, 554, 8200 and its IP

address is 192.168.1.23. The other camera's ports are 81, 8001, 555, 8201 and IP is 192.168.1.24.

Afterwards, enable all or TCP protocols. Enable the port map after pressing the 'Save'.

Appendix 2 Port Map

Table of Contents