Preparing The Remote Control - Kenwood KRF-V6300D Instruction Manual

Preparing the remote control

Loading batteries Loading batteries
œ Remove the cover.
∑ Insert batteries.
Insert two (R03) batteries following the polarity
indications.
é Close the cover.
• The supplied batteries may have shorter lives than ordinary
batteries due to use during operation checks.
¤CAUTION
Do not leave the battery near fire or under direct sunlight.
A fire, explosion or excessive heat generation may result.
Operation Operation
When the Standby indicator is lit, the power turns ON when you
press [ RECEIVER] on the remote control unit. When the power
comes ON, press the key you want to operate.
When operating the connected components, always press
the input source key of the component you need to operate
first to swith the remote control unit to the selected input
source mode, and then press the keys of the corresponding
operation.
Operating range (Approx.)
Standby indicator
Infrared ray system
• When the remote-controllable distance gets shorter than before,
replace both batteries with new ones.
• Placing the remote sensor in direct sunlight, or in direct light from
a high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to
prevent malfunction.
Remote sensor
9
English