Preparing The Remote Control - Kenwood 5.1 KRF-V7050D Instruction Manual

18
Speaker placement
Front
speaker
Surround
speaker
Front speakers : Place to the front left and right of the listening position.
Front speakers are required for all surround modes.
Center speaker : Place front and center. This speaker stabilizes the
sound image and helps recreate sound motion. Be sure to connect a
center speaker when using the Dolby 3 Stereo mode.
Surround speakers : Place to the direct left and right, or slightly
behind, the listening position at even heights, approximately 1 meter
above the ears of the listeners. These speakers recreate sound motion
and atmosphere. Required for surround playback.
Subwoofer : Reproduces powerful deep bass sounds.
• Although the ideal surround system consists of all the speakers listed
above, if you don't have a center speaker or a subwoofer, you can
divide those signals between the available speakers in the speaker
settings steps to obtain the best possible surround reproduction from
the speakers you have available.
Channel space switching
(Except for the USA, Canada, UK, Europe, and Australia)
The space between radio channels has been set to the one that prevails
in the area to which the system is shipped. However, if the current
channel space setting does not match the setting in the area where the
system is to be used, for instance when you move from area 1 or area
2 shown in the following table or vice versa, proper reception of AM/FM
broadcasts cannot be expected. In this case, change the channel space
setting in accordance with your area by referring to the following table.
Area
USA, Canada and South
1
American countries
2 Other countries
DE-
EMPHASIS
CHANNEL
SPACE
Move switch lever to match your area with a small screwdriver or
other pointed tool.
Center speaker
Subwoofer
Listening
position
CHANNEL
Space Frequency
FM: 100 kHz
AM: 10 kHz
FM: 50 kHz
AM: 9 kHz
PLAY IN REC OUT PLAY IN PLAY IN PLAY
L
MONITOR
OUT DVD VIDEO 1 VIDEO 1 VIDEO 2 VIDEO
R
75µs
AM 10kHz
FM 100kHz
50µs A
R
AM 9kHz
FM 50kHz
DE-
EMPHASIS
CHANNEL
SPACE

Preparing the remote control

For VR-507 (RC-R0720)
Loading the batteries
1 Remove the cover.
3 Close the cover.
• Insert two AA-size (R6) batteries as indicated by the polarity markings.
For KRF-V7050D (RC-R0613)
Loading the batteries
1 Remove the cover.
3 Close the cover.
2
(
• Insert two AA-size (R6) batteries as indicated by the polarity markings.
Operation
When the STANDBY indicator is lit, the power turns ON when you press
the POWER key on the remote control. When the power comes ON,
press the key you want to operate.
Operating range
(Approx.)
6 m
• When pressing more than one remote control key successively, press
the keys securely by leaving an interval of 1 second or more between
keys.
Notes
1. The supplied batteries may have shorter lives than ordinary batteries due
to use during operation checks.
2. When the remote-controllable distance gets shorter than before, replace
both batteries with new ones.
3. Placing the remote sensor in direct sunlight, or in direct light from a high
frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to prevent
malfunction.
Setting up the system
2 Insert the batteries.
2 Insert the batteries.
1
Infrared ray system
Remote sensor