Preparing The Remote Control - Kenwood VR-716 Instruction Manual

Before applying the pow er

Preparing the remote control

Loading the batteries
1 Remove the cover.
3 Close the cover.
• Insert tw o AA-size (R6) batteries as indicated by the polarity markings.
Operation
When the STANDBY indicator is lit, the pow er turns ON w hen you press
the POWER RCVR key on the remote control. When the pow er comes
ON, press the key you w ant to operate.
Operating range
(Approx.)
6 m
POWER
RCVR
• When pressing more than one remote control key successively,
press the keys securely by leaving an interval of 1 second or more
betw een keys.
Notes
1. The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checks.
2. When the remote-controllable distance gets shorter than before,
replace both batteries w ith new ones.
3. Placing the remote sensor in direct sunlight, or in direct light from
a high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to
prevent malfunction.
4 EN
2 Insert the batteries.
Remote sensor
Infrared ray system
+ +
¢
4
+
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes
or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction
manual. The user could lose the authority to operate this equipment
if an unauthorized change or modification is made.
NOTE:
This equipment has been tested and found to comply w ith the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment may
cause harmful interference to radio communications, if it is not
installed and used in accordance w ith the instructions. How ever,
there is no guarantee that interference w ill not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, w hich can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the follow ing measures:
– – Reorient or relocate the receiving antenna.
– – Increase the separation betw een the equipment and receiver.
– – Connect the equipment into an outlet on a circuit different from
that to w hich the receiver is connected.
– – Consult the dealer or an experienced radio / TV technician for help.
For the U.S.A.
Note to CATV system installer:
This reminder is provided to call the CATV system installer' s attention
to Article 820-40 of the NEC that provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be
connected to the grounding system of the building, as close to the
point of cable entry as practical.
E
As an
Corporation has determined that this product
meets the
energy efficiency. This product can save
energy. Saving energy reduces air pollution and low ers utility bills.
S
TAR ® Partner, Kenw ood
NERGY
E S TAR ® guidelines for
NERGY