Kenwood KRF-V6300D Instruction Manual page 45

Tuner
Symptom
Radio stations cannot be received.
Interference
A station which was preset cannot be received by pressing
the corresponding numeric key.
Remote control unit
Symptom
Remote control operation is not possible.
Cause
No antenna is connected.
The broadcast band is not set properly.
The frequency of the desired station is not tuned.
Noise due to ignition of an automobile.
Noise due to interference from an electric appliance.
Noise due to a nearby TV set.
The preset station belongs to a frequency that cannot be
received.
Cause
The remote control is set to the DVD player operation
mode.
Batteries are exhausted.
The remote control unit is too far away from the main
system, controlling angle is too large, or there is an
obstacle between this unit and the remote.
The remote control has not been changed to the operation
mode for the Kenwood DVD player you wish to control.
Remedy
Connect an antenna.
Set the broadcast band properly.
Tune the frequency of the desired station.
Install the outdoor antenna away from the road.
Turn off the power to the appliance.
Install the unit farther away from the TV.
Preset a station with a receivable frequency.
Remedy
Press any of the Input Source keys to select the
appropriate operation mode.
Replace with new batteries.
Operate the remote control unit within the controllable
range.
Press the [CD/DVD] or [DVD/6CH] key to activate the
operation mode for the component you want to control
before operation.
&
›
›
fi
9
9
45
English