Troubleshooting - Kenwood KRF-V6300D Instruction Manual

Troubleshooting

Troubles are not always due to malfunction or failure of the system. In case of a trouble, check the following tables before calling for
service.
Amplifier
Symptom
No sound from the speakers.
No sound from the speakers when playing the source
connected with HDMI connection.
The standby indicator blinks and sound is not output.
Sound is not output from one of the speakers.
Sound is not output from the surround
speakers and/or the center speaker, or their sound is
very soft.
When playing a Dolby Digital source signal using a DVD
player, the sound is cut off soon after it starts.
No sound is produced during playback from a DVD player. The input mode is set to digital manual.
A video source cannot be recorded normally.
No video output.
Display is turned off.
44
KRF-V6300D
Cause
The speaker cords are disconnected.
VOLUME is set to the minimum position.
MUTE is ON.
The SPEAKERS switches are set to OFF.
Audio line connection is not made.
Speaker cords are short-circuited.
There may be an internal defect.
The speaker cord is disconnected.
The speaker is not set up correctly.
The surround speaker cords and/or the center speaker
cord is disconnected.
The speaker is not set up correctly.
A surround mode has not been activated.
The surround and/or center volume controls are set to the
minimum level.
There are many possible causes for this problem,
depending on the type of DVD player used.
The software is copy-guarded.
PURE AUDIO MODE is on.
PURE AUDIO MODE is on.
Remedy
Connect it properly referring to <Connecting the
speakers>.
Adjust the volume to a proper level.
Turn OFF the MUTE.
Set the SPEAKERS switch to ON.
Connect the audio line referring to <Connecting
components equipped with HDMI terminals>. !
Turn the power off, eliminate the short-circuiting, then
turn on the power again.
If the standby indicator still blinks after eliminating the
short-circuiting, there may be an internal defect. Switch it
off, unplug the power cord and call for service.
Connect it properly referring to <Connecting the
speakers>.
Set it up properly referring to <Speaker setup>.
Connect it properly referring to <Connecting the
speakers>.
Set it up properly referring to <Speaker setup>.
Select a surround mode.
Adjust the speaker levels using the test tone. £
Set the input mode to digital manual before starting
playback of the Dolby Digital source.
Press the [INPUT MODE] key to select to full auto mode.
Copy-guarded video software cannot be recorded.
Turn off the PURE AUDIO MODE.
While the PURE AUDIO MODE is on, the display is turned
off.
*
w
§
*
¡™
*
¡™
¤
§
§
•
•