Table of Contents
Advertisement
Before applying the power
Unpacking
Unpack the unit carefully and make sure that all accessories are
present.
FM indoor antenna (1)
Remote control unit (1)
RC-R0516E (for the Europe)
RC-R0516 (except for the Europe)
FM antenna adapter (1)
If any accessories are missing, or if the unit is damaged or fails to operate,
notify your dealer immediately. If your unit was shipped to you directly,
notify your shipper immediately. Kenwood recommend that you retain
the original carton and packing materials in case you needs to move or
ship the unit in the future.
Keep this manual handy for future reference.
Preparing the remote control
Loading the batteries
1 Remove the cover.
3 Close the cover.
• Insert two AAA-size (R03) batteries as indicated by the polarity
markings.
4
EN
AM loop antenna (1)
Batteries (R03/AAA) (2)
2 Insert the batteries.
Operation
When the STANDBY indicator is lit, the power turns ON when you press
the POWER
key on the remote control. When the power comes ON,
press the key you want to operate.
Operating range
(Approx.)
• When pressing more than one remote control key successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
Notes
1. The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checks.
2. When the remote-controllable distance gets shorter than before,
replace both batteries with new ones.
3. Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to
prevent malfunction.
Channel space switching
(Except for the Europe and Australia)
The space between radio channels has been set to the one that
prevails in the area to which the system is shipped. However, if the
current channel space setting does not match the setting in the area
where the system is to be used, for instance when you move from
area 1 or area 2 shown in the following table or vice versa, proper
reception of AM/FM broadcasts cannot be expected. In this case,
change the channel space setting in accordance with your area by
referring to the following table.
Area
U.S.A., Canada and South
1.
American countries
2.
Other countries
CHANNEL SPACE
75µs
DVD
SPEAKERS (6 – 16Ω)
AM10kHz
SURR BACK
CENTER
REAR
FRONT
/SW
R
L
R
L
AM
FM100kHz
VIDEO2
GND
VIDEO1
FM
75Ω
ANTENNA
Turn the power OFF by pressing the POWER key before moving the
switch level. Move the switch lever to match your area with a small
screwdriver or other pointed tool, then turn the power ON again.
Remote sensor
Infrared ray system
CHANNEL
Space Frequency
FM: 100 kHz
AM: 10 kHz
FM: 50 kHz
AM: 9 kHz
DE-EMPHASIS
50µs
SUB WOOFER
AM9kHz
DVD
PRE
IN
MONITOR
OUT
VOLTAGE SELECTOR
OUT
SURR BACK
OPTICAL
AC220-
AC110-
FM50kHz
VIDEO1
240V~
120V~
CHANNEL SPACE
VIDEO2
75µs
IN
/L
AM10kHz
R
BS
FM100kHz
VIDEO2
COAXIAL
VIDEO1
R
L
R
L
MONITOR
DVD
IN
OUT
IN
OUT
OUT
AUDIO
S VIDEO
VIDEO
DIGITAL IN
DE-EMPHASIS
50µs
AM9kHz
FM50kHz
AC 110-120V
/220-240V~
50/60Hz
W
Hide quick links:
Advertisement
Table of Contents
