Table of Contents
Advertisement
❏
8. Locate the 3mm plywood components that make up the
fuel line holder. Glue the two matching parts to each other.
Then slide the remaining part into the slots, gluing it to the
other part.
❏
9. Glue the fuel line holder to the bottom of the fi rewall.
❏
10. Install an aluminum fuel plug into the fi ll line and then
push the lines onto the holder.
❏
11. Place a piece of masking tape on the fuselage in line
with each of the wood cowl mounting blocks. Measure back
1" [25.4mm] from the center of each block. Mark a line onto
the tape.
❏
12. Place the cowl onto the fuselage, aligning the stripes
on the cowl with the fuselage. Make a mark on the cowl
where the throttle choke wire contacts the cowl and then cut
away the cowl as needed to provide clearance for the wire.
Tape the cowl in place on the front of the fuselage.
28
Advertisement
Table of Contents
