Unformatted Flash Detected [53]; Unsupported Option In Slot [X] [55]; Weblink Server Not Set Up. Contact System Administrator; Fixing Print Quality Issues - Lexmark MS510 Series Service Manual

Unformatted flash detected [53]

Try one or more of the following:
•
From the printer control, select Continue to stop the defragmentation and continue printing. For non‑touch‑screen
printer models, press
•
Format the flash memory.
Note: If the error message remains, then the flash memory may be defective and need to be replaced.

Unsupported option in slot [x] [55]

1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the unsupported option card from the printer controller board, and then replace it with a supported card.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

Weblink server not set up. Contact system administrator.

Select Continue to clear the message. For non‑touch‑screen printer models, press
Note: If the message appears again, then contact your system support person.

Fixing print quality issues

The symptoms described in this chapter might require replacement of one or more CRUs (Customer Replaceable Units)
designated as supplies or maintenance items, which are the responsibility of the customer. With the customer's
permission, you might need to install a toner cartridge.

Initial print quality check

Before troubleshooting specific print problems, complete the following initial print quality check:
1
The printer must be in a location that follows the recommended operating environment specifications. See
"Operating environment" on page
2
Check the life status of all supplies. Any supply that is low should be replaced.
3
Load 20‑lb plain letter or A4 paper. Make sure the paper guides are properly set and locked. From the control panel,
set the paper size and type to match the paper loaded in the tray.
4
Print a Menu settings page. Be sure to keep the original Menu settings page to restore the customer's custom
settings if needed.
5
Verify on the Menu settings page if the following are set to their default values:
•
Print resolution: 600 dpi
• Toner darkness: 8
to confirm.
281.
Diagnostic information
44
4514-630, -635, -636
to confirm.